Difference between revisions of "CNC Bender v12-20120601"
From ATTWiki
| Line 18: | Line 18: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=400> | <td width=400> | ||
| − | If the Rear Bend Boost mode is OFF in low level, then switching it ON in any Bend option cell will be ignored. | + | If the Rear Bend Boost mode is OFF in low level, then switching it ON in any Bend option cell will NOT have any effect (it will be ignored). |
<br> | <br> | ||
</td> | </td> | ||
| Line 28: | Line 28: | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
=Other Pages= | =Other Pages= | ||
Latest revision as of 17:50, 1 June 2012
v12-20111229
|
|
Repair - Rear Bend Boost Mode
|
If the Rear Bend Boost mode is OFF in low level, then switching it ON in any Bend option cell will NOT have any effect (it will be ignored).
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
