Difference between revisions of "CNC Bender v12-20120517"
From ATTWiki
| Line 37: | Line 37: | ||
<td width=400> | <td width=400> | ||
The part counter values would not always enable in the Run Page. This has been repaired. | The part counter values would not always enable in the Run Page. This has been repaired. | ||
| + | <br><br> | ||
| + | [[image:cnc_bender_counterboxes.jpg|300px]] | ||
</td> | </td> | ||
Revision as of 00:19, 17 May 2012
v12-20111229
|
|
New Feature - PDA Return in Test Bend Menu
|
You can now return the PDA in the Test Bend menu after a bend is complete.
|
|
Repaired Feature - Fix to Part Counter Boxes in Run Page
|
The part counter values would not always enable in the Run Page. This has been repaired.
|
Enhanced Feature - Part Name is Now Always Trimmed
|
Preceding and trailing spaces cause problems because they are hard to detect. This can cause subtle problems with part synchronization when building parts to CNC Processor.
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
