Difference between revisions of "CNC Bender v12-20120517"
From ATTWiki
| Line 28: | Line 28: | ||
</tr> | </tr> | ||
</table> | </table> | ||
| + | |||
| + | |||
| + | ===[[image:Check.jpg|25px]] Enhanced Feature - Part Name is Now Always Trimmed === | ||
| + | |||
| + | <table cellpadding=10> | ||
| + | <tr valign=top> | ||
| + | <td width=400> | ||
| + | Preceding and trailing spaces cause problems because they are hard to detect. The part name is now always trimmed when the operator includes preceding or trailing spaces. | ||
| + | </td> | ||
| + | |||
| + | <td width=300> | ||
| + | |||
| + | |||
| + | </td> | ||
| + | |||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | |||
=Other Pages= | =Other Pages= | ||
Revision as of 16:55, 16 May 2012
v12-20111229
|
|
Repaired Feature - Part Counter Boxes in Run Page
|
The counter values would not always enable in the Run Page. This has been repaired. |
|
Enhanced Feature - Part Name is Now Always Trimmed
|
Preceding and trailing spaces cause problems because they are hard to detect. The part name is now always trimmed when the operator includes preceding or trailing spaces. |
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
