Difference between revisions of "CNC Bender v12-20120517"
From ATTWiki
| Line 13: | Line 13: | ||
</table> | </table> | ||
__NOTOC__ | __NOTOC__ | ||
| − | ===[[image:Check.jpg|25px]] Repaired | + | ===[[image:Check.jpg|25px]] Repaired Feature - Part Counter Boxes in Run Page === |
<table cellpadding=10> | <table cellpadding=10> | ||
| Line 28: | Line 28: | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
| − | |||
=Other Pages= | =Other Pages= | ||
Revision as of 14:42, 16 May 2012
v12-20111229
|
|
Repaired Feature - Part Counter Boxes in Run Page
|
The counter values would not always enable in the Run Page. This has been repaired. |
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
