Difference between revisions of "Main.axislist"
From ATTWiki
| Line 1: | Line 1: | ||
| + | __toc__ | ||
| + | |||
===What is It?=== | ===What is It?=== | ||
The main.axislist file exists in the c:\cnc\config\axis folder. It contains setup information for each of the controlled axes on a CNC bender. | The main.axislist file exists in the c:\cnc\config\axis folder. It contains setup information for each of the controlled axes on a CNC bender. | ||
| + | |||
| + | ===Sections=== | ||
| + | Each of the sections in the main.axislist is set apart with an axis section label like this: | ||
| + | |||
| + | <pre>[Axis 1]</pre> | ||
| + | |||
===Properties=== | ===Properties=== | ||
Revision as of 14:46, 17 July 2006
Contents |
What is It?
The main.axislist file exists in the c:\cnc\config\axis folder. It contains setup information for each of the controlled axes on a CNC bender.
Sections
Each of the sections in the main.axislist is set apart with an axis section label like this:
[Axis 1]
Properties
As of 10.0.5.9:
Delay After Cycle Start
--Mcone 10:37, 17 July 2006 (EDT)
