Revision 1.65

Back to VTube-LASER

The radius correction menu allows VTube-LASER to correct push-bends on Unison Limited benders.

The menu will send data directly to any bender that can read our radius transfer files. The menu can be accessed from the Radius Stripe Scan menu.

The Bender Setup window has a new easier-to-view color scheme.

The bend setup grid has a new column for inverting rotations that are sent out to the bender. This allows for sending the rotation the opposite direction - then remembering the inversion for next time the project is run.

The new radius stripe scanning method is more accurate as of this version of VTube due to a new torus-fit engine included in VTube.

A new bender chart was added to the report template to include the bender data + corrections chart

The Report Preview menu now allows you to change the printer and the paper orientation before printing.

The Laser probe grid now has a separate checkbox for automatically enabling either laser or tactile measuring for radius stripe scans.

The Scan Rate grid now has a separate controls for radius stripe scans.

• The MOVE command was repaired from the previous version so that it works properly.
• The System Options menu allows you to browse directly into support folders from inside VTube-LASER.
• VTube-LASER now uses the "All Users" or "ProgramData" folders to store configuration data for all users of the FARO computer.
• The Winton Machinery bender protocol was enhanced so that it automatically loads a template if no data is present in memory.

• No known issues

VTube-LASER Training Video - How to perform effective end scans.