Difference between revisions of "VTube-LASER v1.59"
From ATTWiki
| Line 72: | Line 72: | ||
<td> | <td> | ||
[[image:vtube_laser_linear_units.jpg]] | [[image:vtube_laser_linear_units.jpg]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | <br><br> | ||
| + | |||
| + | |||
| + | ===[[image:Check.jpg|25px]] REPAIR- Laser Active Initialization === | ||
| + | <table> | ||
| + | <tr> | ||
| + | <td width=200> | ||
| + | In previous versions, VTube required the operator to enter Measure Setup at least one time when coming into Laser Mode in order to setup the Laser active mode.<br><br> | ||
| + | This has been corrected in this version. It is no longer necessary to enter measure setup if you know the setup is correct.</td> | ||
| + | <td> | ||
| + | [[image:vtube_laser_measuresetup.jpg]] | ||
</td> | </td> | ||
</tr> | </tr> | ||
Revision as of 13:48, 10 February 2011
|
Revision 1.59Back to VTube-LASER |
|
NEW: Help Reference for LASER Mode
|
Now VTube-LASER has its own help reference. |
|
REPAIR: Mix ball probe and laser measurement
|
Using ball probe measurements on the end scans and and laser measurements in the cylinder straights now offsets the ball radius point properly in every case. |
|
ENHANCEMENT- Part Name is Used as Filename When Part Name Changes
|
In previous versions, the part name was used as the filename only if the previous filename was empty.
|
|
REPAIR- Linear Units Set Properly At Load
|
In previous versions, an Inch part would sometimes load then reset to Millimeters on the screen.
|
|
REPAIR- Laser Active Initialization
|
In previous versions, VTube required the operator to enter Measure Setup at least one time when coming into Laser Mode in order to setup the Laser active mode. |
|
Changes to VTube-STEP
|
Issues with this version fixed in next version
|
Other Pages
- Back to VTube-LASER
