Difference between revisions of "VTube-LASER v1.59"
From ATTWiki
| Line 56: | Line 56: | ||
<td> | <td> | ||
[[image:vtube_savefile_partname.jpg]] | [[image:vtube_savefile_partname.jpg]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | <br><br> | ||
| + | |||
| + | |||
| + | ===[[image:Check.jpg|25px]] REPAIR- Linear Units Set Properly At Load === | ||
| + | <table> | ||
| + | <tr> | ||
| + | <td width=200> | ||
| + | In previous versions, the an Inch part would load and sometimes reset to Millimeters on the screen. | ||
| + | <br><br> | ||
| + | This has been corrected in this version.</td> | ||
| + | <td> | ||
| + | [[image:vtube_laser_linear_units.jpg]] | ||
</td> | </td> | ||
</tr> | </tr> | ||
Revision as of 21:32, 9 February 2011
|
Revision 1.59Back to VTube-LASER |
|
NEW: Help Reference for LASER Mode
|
Now VTube-LASER has its own help reference. |
|
REPAIR: Mix ball probe and laser measurement
|
Using ball probe measurements on the end scans and and laser measurements in the cylinder straights now offsets the ball radius point properly in every case. |
|
ENHANCEMENT- Part Name is Used as Filename When Part Name Changes
|
In previous versions, the part name was used as the filename only if the previous filename was empty.
|
|
REPAIR- Linear Units Set Properly At Load
|
In previous versions, the an Inch part would load and sometimes reset to Millimeters on the screen.
|
|
Changes to VTube-STEP
|
Issues with this version fixed in next version
|
Other Pages
- Back to VTube-LASER
