Difference between revisions of "VTube-LASER v1.59"
From ATTWiki
| Line 65: | Line 65: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=500> | <td width=500> | ||
| − | * See [[VTube-STEP v1.59]] for changes to the STEP mode.</td> | + | * See [[VTube-STEP v1.59]] for changes to the STEP mode in this version.</td> |
<td width=300> | <td width=300> | ||
</td> | </td> | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
===[[image:Check.jpg|25px]] Issues with this version fixed in next version=== | ===[[image:Check.jpg|25px]] Issues with this version fixed in next version=== | ||
Revision as of 21:23, 9 February 2011
|
Revision 1.59Back to VTube-LASER |
|
NEW: Help Reference for LASER Mode
|
Now VTube-LASER has its own help reference. |
|
REPAIR: Mix ball probe and laser measurement
|
Using ball probe measurements on the end scans and and laser measurements in the cylinder straights now offsets the ball radius point properly in every case. |
|
ENHANCEMENT- Part Name is Used as Filename When Part Name Changes
|
In previous versions, the part name was used as the filename only if the previous filename was empty.
|
|
Changes to VTube-STEP
|
Issues with this version fixed in next version
|
Other Pages
- Back to VTube-LASER
