Difference between revisions of "VTube-STEP v1.59"
From ATTWiki
| Line 1: | Line 1: | ||
| − | [[image:vtube-step_logo.jpg| | + | <table> |
| + | <tr cellpadding=10> | ||
| + | <td width=225> | ||
| + | [[image:vtube-step_logo.jpg|200px]] | ||
| + | ==Revision 1.59== | ||
| + | * Back to [[VTube-STEP]] | ||
| + | * Back to [[VTube-LASER]] | ||
| + | </td> | ||
| + | <td width=300> | ||
| + | [[image:vtube-step_logo.jpg|300px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | |||
===[[image:Check.jpg|25px]] ENHANCED - Added Automatic Support for 180 Degree Bends=== | ===[[image:Check.jpg|25px]] ENHANCED - Added Automatic Support for 180 Degree Bends=== | ||
Revision as of 21:10, 9 February 2011
|
Revision 1.59
|
|
ENHANCED - Added Automatic Support for 180 Degree Bends
|
There is no single intersection point for 180 degree bends - so they require special handling by automatically splitting the bend into two sequential bends. The image on the right shows two parallel straights that form a 180 degree bend. The built-in logic handles the creation of the two intersection points and splitting of the bend into two 90 degree bends with a zero straight. |
|
FIX - Straights with Length of Zero Handling
|
VTube now no longer tries to forms straights with a practical length of zero. They are omitted from the solid model created. |
Other Pages
- Back to the VTube page
