Difference between revisions of "CNC Bender v12-20101005"
From ATTWiki
| Line 42: | Line 42: | ||
| + | ===[[image:Check.jpg|25px]] NEW - FEED TORQUE ZEROED DURING MANDREL RETRACT === | ||
| + | |||
| + | <table cellpadding=10> | ||
| + | <tr valign=top> | ||
| + | <td width=200> | ||
| + | The FEED TORQUE is always set to ZERO% during mandrel retractions. | ||
| + | </td> | ||
| + | <td> | ||
| + | |||
| + | </td> | ||
| + | </tr> | ||
| + | |||
| + | |||
| + | </table> | ||
=Other Pages= | =Other Pages= | ||
Revision as of 13:45, 7 October 2010
|
|
Contents |
NEW - LOAD and START in RUN PAGE
|
The LOAD and START values can now be programmed in the RUN PAGE. |
NEW - FEED AXIS POSITION DISPLAY FROM BACK OR FRONT
|
The FEED axis values can be displayed from the front or the back by pressing a toggle button in the RUN PAGE. |
NEW - FEED TORQUE ZEROED DURING MANDREL RETRACT
|
The FEED TORQUE is always set to ZERO% during mandrel retractions. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
