Difference between revisions of "CNC Bender v11-20091229"

From ATTWiki
Jump to: navigation, search
Line 1: Line 1:
 +
 
<table>
 
<table>
 
<tr>
 
<tr>
Line 4: Line 5:
 
[[image:Cncbender_logo_pushbending.png]]
 
[[image:Cncbender_logo_pushbending.png]]
 
<br>
 
<br>
 +
 +
 +
<table>
 +
<tr>
 +
<td>
 +
Type of Upgrade: '''Optimization''' and '''New Feature'''
 +
</td>
 +
<td>
 +
The changes in this version are designed to make CNC Bender more accurate, run faster, and perform new tasks.
 +
</td>
 +
</tr>
 +
</table>
  
 
===[[image:Check.jpg|25px]] NEW - Tube Mandrel Check and Destroyer Feature===
 
===[[image:Check.jpg|25px]] NEW - Tube Mandrel Check and Destroyer Feature===
Line 23: Line 36:
 
<br><br>
 
<br><br>
  
−
<table>
 
−
<tr>
 
−
<td>
 
−
Type of Upgrade: '''Optimization''' and '''New Feature'''
 
−
</td>
 
−
<td>
 
−
The changes in this version are designed to make CNC Bender more accurate, run faster, and perform new tasks.
 
−
</td>
 
−
</tr>
 
−
</table>
 
  
 
</td>
 
</td>

Revision as of 22:23, 30 December 2009

Cncbender logo pushbending.png


Type of Upgrade: Optimization and New Feature

The changes in this version are designed to make CNC Bender more accurate, run faster, and perform new tasks.

Check.jpg NEW - Tube Mandrel Check and Destroyer Feature

  • CNC Bender can now automatically check for the existence of a broken mandrel after a mandrel extraction.

  • If the mandrel is broken, then CNC Bender process list logic requires the operator to place the tube in a tube destroyer to crush the tube to prevent it from being used in other machinery in the cell.

Tubedestroyer.jpg

Mandrelcheck actuator.jpg




Operatorstation model.jpg

Contents


Check.jpg ENHANCE- Updates to CNC Processor to improve motion command logic

  • There were circumstances were incremental motion commands could be issued twice when only one command was necessary.

  • This version of CNC Bender removes the potential for double calls to incremental motion commands

Bendarm blur vb150.jpg



Check.jpg ENHANCE- PreBend Rotate to Start Angle User-Interface Change

  • The PreBend ROTATE TO START ANGLE feature is now only available in the PreBend Dynamic Options list

  • This reduces confusion so that the operator knows that the feature is available in a single location.

Rotatetostart dynamicoption.jpg

Prebendcarriagemenu removed rotate to start.jpg




Other Pages

Retrieved from "http://www.advancedtubular.wiki/index.php?title=CNC_Bender_v11-20091229&oldid=13043"