Revision 1.62

Back to VTube-LASER

Analysis of end scans is now at least twice as fast as in version 1.61.

When end-scans are taking more time than a few seconds, a progress window will display.

Now all scan rates are determined by either a TIMER or a DISTANCE.

For end-scans, use a timer and set the timer value to 0 milliseconds.

For cylinder scans, you can use DISTANCE and set the Cylinder Scan Distance to whatever value is convenient for separation.

VTube-LASER now uses multiple points to qualify the end-scan. This gives it better protection against outlier points.

A new End-Scan Fit window gives information about how many points were used in the end-trim, and the span of all the point positions. Higher point counts with lower spans indicate a better data set for end-trim.

• The A End and B End OFFSETs other than ZERO caused a problem where end-scans would never be qualified. This has been resolved in this version.

• Diameter measures now use the Cylinder scan rate filter setup values. (Fixed in VTube-LASER v1.63)
  
  

VTube-LASER Training Video - How to perform effective end scans.