Difference between revisions of "CNC Bender v12-20110112"
From ATTWiki
(5 intermediate revisions by one user not shown) | |||
Line 14: | Line 14: | ||
− | ===[[image:Check.jpg|25px]] REPAIR - | + | ===[[image:Check.jpg|25px]] REPAIR - Test Bend's Bend-PD-Assist Feature === |
<table cellpadding=10> | <table cellpadding=10> | ||
Line 22: | Line 22: | ||
</td> | </td> | ||
<td> | <td> | ||
− | [[image: | + | [[image:cncbender_testbend_BendPDAbutton_v12-20110112.jpg]] |
+ | </td> | ||
+ | </tr> | ||
+ | </table> | ||
+ | |||
+ | |||
+ | ===[[image:Check.jpg|25px]] ENHANCED - Inside Wiper Swing Away Test === | ||
+ | |||
+ | <table cellpadding=10> | ||
+ | <tr valign=top> | ||
+ | <td width=200> | ||
+ | The Inside Wiper Swing Away proximity switches can now defined normally open or normally closed. | ||
+ | <br><br> | ||
+ | The "active" state for this input is now defined by the CIO dictionary - rather than assumed to be always just "high" - it can now "high" or "low." | ||
+ | </td> | ||
+ | <td> | ||
+ | [[image:cncbender_insidewiperswingaway_v12-20110112.jpg|400px]] | ||
</td> | </td> | ||
</tr> | </tr> |
Latest revision as of 20:28, 13 January 2011
Contents |
REPAIR - Test Bend's Bend-PD-Assist Feature
The Test Bend page now works properly with the PDA-RVG profiles. |
ENHANCED - Inside Wiper Swing Away Test
The Inside Wiper Swing Away proximity switches can now defined normally open or normally closed.
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands