Difference between revisions of "Cycle Hold"
(→Safe Mode CYCLE HOLD) |
(→Regular CYCLE HOLD) |
||
| (12 intermediate revisions by one user not shown) | |||
| Line 5: | Line 5: | ||
# Regular Cycle Hold | # Regular Cycle Hold | ||
# [[Safe Mode Cycle Hold]] | # [[Safe Mode Cycle Hold]] | ||
| + | |||
| + | __NOTOC__ | ||
| + | |||
| + | ==CYCLE HOLD Button== | ||
| + | <table> | ||
| + | <tr> | ||
| + | <td>Inactive - Button is not illuminated</td> | ||
| + | <td>[[image:cyclehold_inactive.jpg|400px]]</td> | ||
| + | |||
| + | </tr> | ||
| + | |||
| + | <tr> | ||
| + | <td>Active - Button is illuminated</td> | ||
| + | <td>[[image:cyclehold_active.jpg|400px]]</td> | ||
| + | </tr> | ||
| + | |||
| + | </table> | ||
| + | |||
| + | |||
==Regular CYCLE HOLD== | ==Regular CYCLE HOLD== | ||
| Line 11: | Line 30: | ||
<table cellpadding="35"> | <table cellpadding="35"> | ||
<tr><td width=10></td> | <tr><td width=10></td> | ||
| + | <td>[[image:warning.jpg|100px]]</td> | ||
<td width=300 bgcolor="#f0f0f0"> | <td width=300 bgcolor="#f0f0f0"> | ||
<font size=5>[[image:Gear_warning.jpg]] <b>SAFETY NOTE</b><br><br></font> | <font size=5>[[image:Gear_warning.jpg]] <b>SAFETY NOTE</b><br><br></font> | ||
| Line 24: | Line 44: | ||
==Other Pages== | ==Other Pages== | ||
| − | *See also [[CNC Bender v11-20090827]] | + | *See also [[CNC Bender v11-20090827]] (Secondary processes now use Cycle Hold) |
| + | *Back to [[CNC Bender]] | ||
| + | *Back to [[CNC Bender Software Updates]] | ||
Latest revision as of 21:18, 26 September 2009
Cycle Hold is the button that sets CNC Bender into a pause state for motion. Cycle Start is the opposite of Cycle Hold.
There are two Cycle Hold states:
- Regular Cycle Hold
- Safe Mode Cycle Hold
CYCLE HOLD Button
| Inactive - Button is not illuminated |  |
| Active - Button is illuminated |  |
Regular CYCLE HOLD
In regular Cycle Hold, the bender pauses, but all axes stay energized.
 |
|
Safe Mode CYCLE HOLD
Safe Mode Cycle Hold is activated when the safety mat or safety scanners are activated. In this state, the bender is de-energizes all axes and most outputs. See the Safe Mode Cycle Hold page for more details.
Other Pages
- See also CNC Bender v11-20090827 (Secondary processes now use Cycle Hold)
- Back to CNC Bender
- Back to CNC Bender Software Updates
