Difference between revisions of "CNC Bender LiteControl 10.0.5.9g"

From ATTWiki
Jump to: navigation, search
(25px New General Dynamic OPTION: Allow Monitor for Chuck Close Button)
(Other Pages)
Line 19: Line 19:
  
 
=Other Pages=
 
=Other Pages=
 +
*Read about [[LiteControl]]
 
*Back to [[CNC Bender]]
 
*Back to [[CNC Bender]]
 
*Back to [[CNC Bender Software Updates]]
 
*Back to [[CNC Bender Software Updates]]

Revision as of 02:18, 31 May 2008

Cncbender litcontrol logo.jpg

Operatorstation model.jpg

Contents


This is a minor change to an older version of CNC Bender LiteControl

Check.jpg New General Dynamic OPTION: Allow Monitor for Chuck Close Button

The chuck close button could automatically close the chuck at any point during a bend cycle. This could cause a problem for customers that skip the run buttons in hitch feed mode, as the chuck could close at the wrong time during hitch feeding. Customers wanted this prevented, so we've added a General Dynamic Option "Always Monitor for Chuck Close Button" with a default state of DISABLED.

Cncbender litcontrol monitorchuckclose.jpg



If this option is disabled, then CNC Bender will not monitor for the chuck close button unless it is specifically called for in the process list by CNC Processor.

Other Pages