Difference between revisions of "CNC Bender LiteControl 10.0.5.9g"
From ATTWiki
(→CHANGES to CNC BENDER LITECONTROL) |
|||
Line 8: | Line 8: | ||
===[[image:Check.jpg|25px]] New General Dynamic OPTION: Allow Monitor for Chuck Close Button === | ===[[image:Check.jpg|25px]] New General Dynamic OPTION: Allow Monitor for Chuck Close Button === | ||
− | The chuck close button could automatically close the chuck at any point during a bend cycle. | + | |
+ | The chuck close button could automatically close the chuck at any point during a bend cycle. This could cause a problem for customers that skip the run buttons in [[hitch feed]] mode, as the chuck could close at the wrong time during hitch feeding. Customers wanted this prevented, so we've added a General Dynamic Option "Always Monitor for Chuck Close Button" with a default state of DISABLED. | ||
<br><br> | <br><br> | ||
− | |||
− | |||
+ | [[image:Cncbender_litcontrol_monitorchuckclose.jpg]] | ||
<br><br> | <br><br> |
Revision as of 02:13, 31 May 2008
Contents |
This is a minor change to an older version of CNC Bender LiteControl
New General Dynamic OPTION: Allow Monitor for Chuck Close Button
The chuck close button could automatically close the chuck at any point during a bend cycle. This could cause a problem for customers that skip the run buttons in hitch feed mode, as the chuck could close at the wrong time during hitch feeding. Customers wanted this prevented, so we've added a General Dynamic Option "Always Monitor for Chuck Close Button" with a default state of DISABLED.
If this option is disabled, then CNC Bender will not monitor for the chuck close button unless it is specifically called for in the process list by CNC Processor.
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates