Difference between revisions of "DOCS"

From ATTWiki
Jump to: navigation, search
(Principles for Communication with SVNET)
(Principles for Communication with SVNET)
Line 115: Line 115:
 
A RECALL from a bender '''clears''' the results of a measure.<br><br>
 
A RECALL from a bender '''clears''' the results of a measure.<br><br>
  
Therefore, it is not possible to perform the corrections steps in this order:<br>
+
Therefore, it is NOT possible to perform the corrections steps in this order:<br>
 
<br>
 
<br>
 
#MEASURE
 
#MEASURE
 
#RECALL
 
#RECALL
#CORRECT (Adjust) the bender data
+
#CORRECT LRA
 +
 
 +
 
 
</td>
 
</td>
 
</tr>
 
</tr>

Revision as of 06:05, 21 December 2007

Docs screen1.jpg

DOCS is a software package that is sold by Romer. The word "DOCS" means Data Overlay Camera System. Read more about DOCS at these sites:





Contents

Screen Image

This is a screen image from our test license of DOCS software.

Romer docs egrtube.jpg


Comparing DOCS to Supravision

Supravision and DOCS are developed by Romer. Supravision is an older program that is quite stable. The DOCS software is much newer.

DOCS Software

Supravision Software

Active - Continued development

Static - No more development

Allows for the measurement of tube data and non-tube data surrounding the tube - including brackets and other fabrications

Measures only tube shapes

Can use contact or non-contact measurement

Can only use non-contact measurement of tube shapes

Can measure multiple tubes in a single DOCS file

Can measure one tube per Supravision file

We have no experience with DOCS beyond a demo. It appears to be fairly simple to setup for tube measurement.

Measuring tube shapes is simple after you understand the structure of Supravision menus.



Our Recommendation

As of December, 2007, we have been given a license of DOCS software for evaluation and testing with our Benderlink software.

This software is moderately stable and is capable of Supravision network communications. In comparing the two packages, we recommend that tube fabricators choose DOCS over Supravision because of the new capabilities within DOCS.

Communication with Supravision Network Protocol

See this link for information on which version of DOCS will communicate using SVNET: [1]


Principles for Communication with SVNET

Principle

Reason

Perform a RECALL before a MEASURE and BEST FIT if you anticipate the possibility of making a correction after a measurement.

A RECALL from a bender clears the results of a measure.

Therefore, it is NOT possible to perform the corrections steps in this order:

  1. MEASURE
  2. RECALL
  3. CORRECT LRA


2 - Be careful to confirm that the incoming data changed the CLRA section of the data alone (and not the nominal LRA).

If a matching part number is found in memory in DOCS, then a bender data RECALLs only changes the CORRECTED LRA data. However, in other cases, DOCs may assume that you intend to create a new MASTER part with the incoming data.

Can use contact or non-contact measurement

Can only use non-contact measurement of tube shapes

Can measure multiple tubes in a single DOCS file

Can measure one tube per Supravision file

We have no experience with DOCS beyond a demo. It appears to be fairly simple to setup for tube measurement.

Measuring tube shapes is simple after you understand the structure of Supravision menus.