Difference between revisions of "VTube-LASER v2.9.5"
From ATTWiki
(→25pxENHANCED- FASTER USER INTERFACE) |
(→25pxNEW - SEPARATE PERSPECTIVE MODES FOR STEP and LASER WINDOWS) |
||
Line 72: | Line 72: | ||
[[image:vtl_2.9.5_perspective.png|400px]]<br> | [[image:vtl_2.9.5_perspective.png|400px]]<br> | ||
[[image:vts_2.9.5_perspective.png|400px]] | [[image:vts_2.9.5_perspective.png|400px]] | ||
+ | </td> | ||
+ | </tr> | ||
+ | |||
+ | </table> | ||
+ | <br><br> | ||
+ | |||
+ | |||
+ | |||
+ | ==[[image:Check.jpg|25px]]NEW - REQUEST REVERSE CALC WHEN EXITING THE LRA GRIDS== | ||
+ | |||
+ | <table cellpadding=10 width=800> | ||
+ | <tr valign=top> | ||
+ | |||
+ | <td width=400> | ||
+ | When you edit the LRA grid, then VTube-LASER now assumes that you probably mean to perform a reverse calc.<br><br> | ||
+ | If you exit the grid, then it will immediately ask you if you intended to perform a Reverse Calc.<br><br> | ||
+ | This is active in both the MASTER and the MEASURED LRA grids.</td> | ||
+ | |||
+ | <td> | ||
+ | [[image:vtl_2.9.5 request reverse calc.png|600px]] | ||
</td> | </td> | ||
</tr> | </tr> |
Revision as of 01:59, 28 February 2018
Revision 2.9.5Release Date: February 19, 2018
|
Contents |
ENHANCED- FASTER USER INTERFACE
VTube is now faster due to some important changes to the user interface. |
FIX - SOLID MODEL IMAGE PRINT IN REPORTS
VTube handles multiple displays. |
NEW - SEPARATE PERSPECTIVE MODES FOR STEP and LASER WINDOWS
In previous versions, there was only a single Perspective Mode switch. |
NEW - REQUEST REVERSE CALC WHEN EXITING THE LRA GRIDS
When you edit the LRA grid, then VTube-LASER now assumes that you probably mean to perform a reverse calc. |
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature