Difference between revisions of "VTube-LASER End Point Deviations"
From ATTWiki
(→Three Main End Point Deviations) |
(→Other Pages) |
||
Line 77: | Line 77: | ||
* See also [[VTube Intersection Point Tolerances]] | * See also [[VTube Intersection Point Tolerances]] | ||
+ | * [[What are Centerline Tangent Points and Why Are They Important in VTube-LASER?]] | ||
+ | * About [[VTube Intersection Point Tolerances]] | ||
+ | * About [[VTube End Length Offsets]] | ||
* Back to [[VTube-LASER]] | * Back to [[VTube-LASER]] |
Revision as of 01:30, 2 December 2016
This page describes how to find the END POINT deviations.
|
Contents |
Three Types of End Point Deviations
There are three types of end point deviation values calculated during an alignment of the MEASURED to the MASTER tube. |
END LENGTH Deviations
The end length deviations are found at the top of the Inspection menu.
|
AFTER-TRIM Deviations
These are found in the first T1 value and the last T2 value in the Tangents grid.
|
BEFORE-TRIM Deviations
These are found in the Intersection grid values.
|