Difference between revisions of "CNC Bender v12-20130723"
(→v12-20130722) |
(→25px Other Changes) |
||
Line 53: | Line 53: | ||
<td width=300> | <td width=300> | ||
* This version of CNC Bender has a decreased input check time from 125 ms to 16 ms for faster response time.<br><br> | * This version of CNC Bender has a decreased input check time from 125 ms to 16 ms for faster response time.<br><br> | ||
− | * This version has repaired logic issue with BEGIN condition inputs that would cause Commands to show incompleted inputs | + | * This version has repaired logic issue with BEGIN condition inputs that would cause Commands to show incompleted inputs when they were completed.<br><br> |
+ | * This version has repaired logic issue edge detection for inputs. | ||
* This version allows the input for Master Power ON to be either a BEGIN or END style input without causing the bender to to never drop out of AUTO mode.<br><br> | * This version allows the input for Master Power ON to be either a BEGIN or END style input without causing the bender to to never drop out of AUTO mode.<br><br> | ||
* The version allows the Safety Relay ON to be either a BEGIN or END style input without a causing the bender to never drop out of AUTO mode.<br><br> | * The version allows the Safety Relay ON to be either a BEGIN or END style input without a causing the bender to never drop out of AUTO mode.<br><br> |
Revision as of 22:36, 23 July 2013
v12-20130723
|
See CNC Bender Customer Service Page for an update.
NEW: Any Command (COMDEF) can be taught to ignore Cycle Hold
This new feature allows selected COMDEFs to run in the processlist without pausing during CYCLE HOLD. The reason for this new capability is that some customers require that their benders be equipped with palm buttons that must be held during any part of the bending with pinch-point motion. |
NEW: COMDEF Editor Allows Ignoring Cycle Holds in Commands
The COMDEF Editor allows setup technicians to indicate which COMDEFs can safely ignore CYCLE HOLDS |
Other Changes
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands