Difference between revisions of "CNC Bender v12-20120728"
From ATTWiki
| Line 14: | Line 14: | ||
</table> | </table> | ||
__NOTOC__ | __NOTOC__ | ||
| + | |||
| + | === [[image:Check.jpg|25px]] New Batch Converter - Cut Length to CSV Program === | ||
| + | |||
| + | Build a single file filled with Cut Lengths from all the CNC part files in a folder<br> | ||
| + | |||
| + | [[image:CNCBender_BatchConverter_CutLength2CSV.jpg|600px]] | ||
| + | |||
| + | <table cellpadding=10> | ||
| + | <tr valign=top> | ||
| + | <td width=600> | ||
| + | The output file contains PART NAMES separated from CUT LENGTHS with a comma. | ||
| + | </td> | ||
| + | |||
| + | <td width=300> | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
===[[image:Check.jpg|25px]] Enhanced HALT in Processor for Servo Motion=== | ===[[image:Check.jpg|25px]] Enhanced HALT in Processor for Servo Motion=== | ||
Revision as of 00:14, 7 August 2012
v12-20120728
|
|
New Batch Converter - Cut Length to CSV Program
Build a single file filled with Cut Lengths from all the CNC part files in a folder
|
The output file contains PART NAMES separated from CUT LENGTHS with a comma. |
Enhanced HALT in Processor for Servo Motion
|
This version implements a stronger HALT in CNC Processor to be sure motion commands are halted during E-Stop. This will ensure that Processor does not continue to move the bender during an E-Stop type event.
|
Ceased Reporting Error for [BEGIN PROGRAM] Label
|
When this label was encountered in the Processor, any error would be reported in all cases. This has no value - so it is now ignored completely. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
