Difference between revisions of "CNC Bender v12-20120728"
From ATTWiki
| Line 21: | Line 21: | ||
<td width=400> | <td width=400> | ||
This version implements a stronger HALT in CNC Processor to be sure motion commands are halted during E-Stop. This will ensure that Processor does not continue to move the bender during an E-Stop type event. | This version implements a stronger HALT in CNC Processor to be sure motion commands are halted during E-Stop. This will ensure that Processor does not continue to move the bender during an E-Stop type event. | ||
| + | <br> | ||
| + | </td> | ||
| + | |||
| + | <td width=300> | ||
| + | </td> | ||
| + | |||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | ===[[image:Check.jpg|25px]] Ceased Reporting Error for [BEGIN PROGRAM] Label=== | ||
| + | |||
| + | <table cellpadding=10> | ||
| + | <tr valign=top> | ||
| + | <td width=400> | ||
| + | When this label was encountered in the Processor, any error would be reported in all cases. This has no value - so it is now ignored completely. | ||
| + | |||
<br> | <br> | ||
</td> | </td> | ||
Revision as of 17:40, 28 July 2012
v12-20120728
|
|
Enhanced HALT in Processor for Servo Motion
|
This version implements a stronger HALT in CNC Processor to be sure motion commands are halted during E-Stop. This will ensure that Processor does not continue to move the bender during an E-Stop type event.
|
Ceased Reporting Error for [BEGIN PROGRAM] Label
|
When this label was encountered in the Processor, any error would be reported in all cases. This has no value - so it is now ignored completely.
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
