Difference between revisions of "CNC Bender v12-20120622"
From ATTWiki
| Line 69: | Line 69: | ||
</table> | </table> | ||
| − | [[image:cncbender_radiuslevel_for_loading.jpg | + | [[image:cncbender_radiuslevel_for_loading.jpg]] |
===[[image:Check.jpg|25px]] New - Horizontal Axis LOAD Position in PREBEND=== | ===[[image:Check.jpg|25px]] New - Horizontal Axis LOAD Position in PREBEND=== | ||
Revision as of 01:17, 30 June 2012
v12-20120622
|
|
Repair - Recovery Mode Rotate Spin 180
|
The ROTATE axis could incorrectly rotate 360 degrees when recovering from safety mat activation under rare circumstances of the rotate drifting way from zero. This has been fixed.
|
Repair - Robot Clear Bit Can Be High or Low
|
The Robot Clear bit always assumed that the TRUE signal was bit high. But some machines assume the opposite. This has been fixed.
|
New - Radius Level for LOAD Position in PREBEND
|
The new option "Radius Level for Loading" shows a list composed of 5 options for controlling where the carriage is vertically during LOADING the part. These are the five options:
|
New - Horizontal Axis LOAD Position in PREBEND
|
A new option allows the horizontal axis to move to a specific position for loading. This is a two-option feature: |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
