Difference between revisions of "VTube-LASER v1.73"
From ATTWiki
| Line 37: | Line 37: | ||
<td width=300> | <td width=300> | ||
[[image:vtube-laser_cutplaneoffset_changeoffet_v1_73.jpg|300px]] | [[image:vtube-laser_cutplaneoffset_changeoffet_v1_73.jpg|300px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | |||
| + | ===[[image:Check.jpg|25px]] ENHANCED: Cut Plane Offset Value=== | ||
| + | |||
| + | <table cellpadding=10> | ||
| + | <tr valign=top> | ||
| + | <td width=300> | ||
| + | The Cut Plane Offset Value is now displayed above the Cut Plane icon. | ||
| + | <br><br> | ||
| + | </td> | ||
| + | <td width=300> | ||
| + | [[image:vtube-laser_cutplaneoffset_displayoffet_v1_73.jpg|300px]] | ||
</td> | </td> | ||
</tr> | </tr> | ||
Revision as of 21:12, 20 October 2011
|
Revision 1.73Back to VTube-LASER |
|
Contents |
ENHANCED: Fine Tune for FARO Edge
|
The FARO Edge uses a different scan rate than the older arms. VTube-LASER was adjusted to work with the FARO Edge arms. |
ENHANCED: Cut Plane Offset
|
The Cut Plane Offset can now be changed without remeasuring the Cut Plane.
|
|
ENHANCED: Cut Plane Offset Value
|
The Cut Plane Offset Value is now displayed above the Cut Plane icon.
|
|
NEW: Split Bend Model Display
|
New Split Bend model geometry is included on the screen when measuring split bends in order to visually verify the calculations. |
|
Other Changes
|
Issues with this version fixed in newer versions
|
Other Pages
- Back to VTube-LASER
|
VTube-LASER Training Video - How to perform effective end scans. |
|
