Difference between revisions of "CNC Bender v12-20110215"
From ATTWiki
Line 20: | Line 20: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
− | This repairs logic for checking for input for dies: | + | This repairs logic for checking for input for three conditions in the dies:<br><br> |
− | * OK for Feed To Exceed EOT Safe Radius Change: Carriage Cross Slide Input<br> | + | * OK for Feed To Exceed EOT Safe Radius Change: Carriage Cross Slide Input<br><br> |
− | * OK for Feed To Exceed EOT Pressure Die: Pressure Die Home Input<br> | + | * OK for Feed To Exceed EOT Pressure Die: Pressure Die Home Input<br><br> |
− | * OK for Horizontal Head Shift with Clamp Open: Clamp Die Home Input<br> | + | * OK for Horizontal Head Shift with Clamp Open: Clamp Die Home Input<br><br> |
<br> | <br> | ||
</td> | </td> | ||
Line 33: | Line 33: | ||
</table> | </table> | ||
<br><br> | <br><br> | ||
− | |||
=Other Pages= | =Other Pages= |
Revision as of 15:57, 15 February 2011
v12-20110215
|
REPAIR - CNC Processor Die Avoidance Move Checks
This repairs logic for checking for input for three conditions in the dies:
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands