Difference between revisions of "VTube-LASER v1.59"
From ATTWiki
| Line 45: | Line 45: | ||
<br><br> | <br><br> | ||
| + | |||
| + | |||
| + | ===[[image:Check.jpg|25px]] ENHANCEMENT- Part Name is Used as Filename When Part Name Changes === | ||
| + | <table> | ||
| + | <tr> | ||
| + | <td width=300> | ||
| + | In previous versions, the part name was used as the filename only if the previous filename was empty. | ||
| + | <br><br> | ||
| + | Now - when the part name '''changes''', the part name is used as the initial filename in the Save dialog.</td> | ||
| + | <td> | ||
| + | [[image:vtube_savefile_partname.jpg]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
===[[image:Check.jpg|25px]] Changes to VTube-STEP=== | ===[[image:Check.jpg|25px]] Changes to VTube-STEP=== | ||
Revision as of 21:22, 9 February 2011
|
Revision 1.59Back to VTube-LASER |
|
NEW: Help Reference for LASER Mode
|
Now VTube-LASER has its own help reference. |
|
REPAIR: Mix ball probe and laser measurement
|
Using ball probe measurements on the end scans and and laser measurements in the cylinder straights now offsets the ball radius point properly in every case. |
|
ENHANCEMENT- Part Name is Used as Filename When Part Name Changes
|
In previous versions, the part name was used as the filename only if the previous filename was empty.
|
|
Changes to VTube-STEP
|
Issues with this version fixed in next version
|
Other Pages
- Back to VTube-LASER
