Difference between revisions of "CNC Bender v12-20100903"
Line 197: | Line 197: | ||
The new loader is reduced in height and simplified for a cleaner appearance.</td> | The new loader is reduced in height and simplified for a cleaner appearance.</td> | ||
<td> | <td> | ||
− | [[image:cncbender_loader_simple.jpg| | + | [[image:cncbender_loader_simple.jpg|350px]] |
</td> | </td> | ||
</tr> | </tr> | ||
Line 211: | Line 211: | ||
<br><br> | <br><br> | ||
− | |||
− | |||
===[[image:Check.jpg|25px]] NEW- PDA At Home Tolerance === | ===[[image:Check.jpg|25px]] NEW- PDA At Home Tolerance === |
Revision as of 12:16, 1 September 2010
NEW - CYCLE HOLD in Custom Commands and in TEACH Mode
Now CYCLE HOLD anywhere inside a CUSTOM COMMAND either manually entered or taught during TEACH MODE. |
|
ENHANCED - ENABLE Button for STEP and AUTO Modes
The "REQUIRE ENABLE BUTTON" feature, when active, now also monitors for a switch to AUTO or STEP modes from MANUAL mode |
|
ENHANCED - Vertical Head Shift Tolerance Added
The vertical head shift tolerance allows us to skip motion when an axis is close enough to the final position. |
|
ENHANCED - Added CNC Processor Automatic High Pressure Handling
CNC Processor now uses the CIO Name Cross Reference in the Low Level menu to automatically set the high pressure under these two special circumstances:
|
|
ENHANCED - CNC Processor Soft EOT with New Ramp-Down for JOG Speeds
ENHANCED - EMBEDDED TUBE SUPPORT in CNC PROCESSOR
This feature allows CNC Bender's PROCESSOR to control when the tube support is lifted or dropped - and if the drop should be confirmed with an input. This revision adds the CIO Name of Tube Support Output UP in addition to the Down CIO name.
|
|
This revision also adds new logic was added to the tube support to push the support DOWN when homing is in process. This is to overcome the potential for the support driving up into the spindle because the Feed axis does not know where zero is until home is complete. |
ENHANCED - Simplified CNC BENDER Loader
The CNC Bender Loader is used to start CNC Bender in the operator station with a press. |
|
NEW- PDA At Home Tolerance
A new programmable tolerance for checking for PDA at HOME has been added to the Low Level dynamic options. |
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands