Difference between revisions of "CNC Bender v12-20100903"
Line 113: | Line 113: | ||
===[[image:Check.jpg|25px]] ENHANCED - Soft EOT with New Ramp-Down for JOG Speeds=== | ===[[image:Check.jpg|25px]] ENHANCED - Soft EOT with New Ramp-Down for JOG Speeds=== | ||
+ | |||
+ | [[image:joystick.jpg|250px]] | ||
<table cellpadding=10> | <table cellpadding=10> |
Revision as of 00:01, 1 September 2010
NEW - CYCLE HOLD in Custom Commands and in TEACH Mode
Now CYCLE HOLD anywhere inside a CUSTOM COMMAND either manually entered or taught during TEACH MODE. |
|
ENHANCED - ENABLE Button for STEP and AUTO Modes
The "REQUIRE ENABLE BUTTON" feature, when active, now also monitors for a switch to AUTO or STEP modes from MANUAL mode |
|
ENHANCED - Vertical Head Shift Tolerance Added
The vertical head shift tolerance allows us to skip motion when an axis is close enough to the final position. |
|
ENHANCED - Added CNC Processor Automatic High Pressure Handling
CNC Processor now uses the CIO Name Cross Reference in the Low Level menu to automatically set the high pressure under these two special circumstances:
|
|
ENHANCED - Soft EOT with New Ramp-Down for JOG Speeds
During JOGGING - CNC Processor can check for EOT (end of travel) of an axis before it arrives at the true FAULT EOT. This gives the axis a chance to stop jogging before it arrives at a FAULT position or emergency switch.
|
The following section is extracted from an AXIS configuration file soft EOT section:
Example of what to add in each AXIS in the main.axislist file. The value shown here are typical of the BEND axis: Enable EOT=1 Low EOT=0.75 High EOT=191 Jog Speed=10 Jog Speed Approach EOT=0.5 Approach EOT Range=5 |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands