Difference between revisions of "CNC Bender v12-20100707"
From ATTWiki
| Line 19: | Line 19: | ||
<br><br> | <br><br> | ||
The time is setup in the Processor tab of the low level menu, and was previously applied only to the first output module.<br><br> | The time is setup in the Processor tab of the low level menu, and was previously applied only to the first output module.<br><br> | ||
| − | Now it is applied to all the output modules throughout the entire system.</td> | + | |
| + | '''Now it is applied to all the output modules throughout the entire system.'''</td> | ||
<td> | <td> | ||
[[image:modicon_on_din.jpg|250px]]<br> | [[image:modicon_on_din.jpg|250px]]<br> | ||
Revision as of 00:57, 8 July 2010
|
|
ENHANCED - All Output Modules Now Use Extended Sustain Time
|
The sustain time is used to control how long the output modules stay on around the CNC Bender system even if they are not being serviced.
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
