Difference between revisions of "CNC Bender v12-20100707"
From ATTWiki
| Line 16: | Line 16: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
| − | The sustain time is setup in the Processor tab of the low level menu, and was previously applied only to the first output module.<br><br> | + | The sustain time is used to control how long the output modules stay on around the CNC Bender system even if they are not being serviced. |
| + | <br><br> | ||
| + | The time is setup in the Processor tab of the low level menu, and was previously applied only to the first output module.<br><br> | ||
Now it is applied to all the output modules throughout the entire system.</td> | Now it is applied to all the output modules throughout the entire system.</td> | ||
<td> | <td> | ||
Revision as of 00:56, 8 July 2010
|
|
ENHANCED - All Output Modules Now Use Extended Sustain Time
|
The sustain time is used to control how long the output modules stay on around the CNC Bender system even if they are not being serviced.
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
