Difference between revisions of "Overbend Calculator"
From ATTWiki
(→Download Page) |
(→Download Page) |
||
| Line 26: | Line 26: | ||
==Download Page== | ==Download Page== | ||
| − | [[image:download_button.jpg]] [http://advancedtubular.com/setup_overbend.exe Download Overbend Calculator] 30-day Trial Package (Shareware) | + | [[image:download_button.jpg|100px]] [http://advancedtubular.com/setup_overbend.exe Download Overbend Calculator] 30-day Trial Package (Shareware) |
Revision as of 18:50, 16 May 2009
 |
Reduce Scrap & Save Material by Predicting Springback BEFORE Bending the Part |
This is software that calculates overbend necessary to overcome springback in bends.
Three Step Process for Predicting Springback
- STEP 1: Two test bends are made. Typically they are 20 and 120 degrees. The bender is set to bend these angles and a test tube is bent.
- STEP 2: The actual resulting bend angles are measured and entered into the overbend calculator.
- STEP 3: Two values called "proportional" and "fixed" are calculated and used in a springback formula to predict overbend to overcome springback at any angle.
Download Page
Download Overbend Calculator 30-day Trial Package (Shareware)
