Difference between revisions of "How to Ensure Good End Scans in VTube-LASER"
From ATTWiki
(→Tangent Point Deviation Positions Form Spherical Radius True Positions) |
(→Use Visual Feedback) |
||
| Line 36: | Line 36: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
| − | This is an example of the the end point projected so that it is in line with the end wall | + | In VTube-LASER, operators can use visual feedback to ensure that end point projections are good. This is an example of the the end point projected so that it is in line with the end wall.<br><br> |
| + | The end wall is clearly seen in the purple points in this scan. The orange end point is lined up with the end wall. Therefore, this was a very good end scan.<td> | ||
</td> | </td> | ||
<td> | <td> | ||
[[image:VTube-LASER_End_Scan_Example.png|500px]] | [[image:VTube-LASER_End_Scan_Example.png|500px]] | ||
</tr> | </tr> | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
</table> | </table> | ||
<br><br> | <br><br> | ||
Revision as of 18:19, 7 December 2020
|
|
|
Contents |
REPEATABLE END SCANS
|
Repeatability issues on the ends is the most common problem in GR&R tests. Fortunately it is also the easiest to fix. It involves training users to perform an easy check after VTube calculates the end points visually. |
Use Visual Feedback
|
In VTube-LASER, operators can use visual feedback to ensure that end point projections are good. This is an example of the the end point projected so that it is in line with the end wall. |
|
Intersection Point 3D Deviations Positions Form Spherical Radius True Positions
| The 3D deviations for the XYZ centerline end and intersection points are also the equivalent of spherical radius true position values. The 3D deviations shown in the XYZ grid in the Inspection Data menu show these deviation values. |
|
Other Pages
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
