Calibration-Leapfrog-Move Targets

This conical seat target is useful for calibrating ball probes.

In sets of three or more, they turn into leapfrog or tube move targets that help VTube-LASER operators measure parts longer than the FARO arm reach using the arm leapfrog or tube move.

Back to VTube-LASER

Features

The targets use a magnetic base to attach to any metalic surface or metal spring clamp.
They are good for standard 3 or 6 millimeter FARO probes.
The pillar finish is industrial-grade glossy white finish.

Leapfrog

VTube can leapfrog the arm over the tube in the middle of any measurement. In order to accurately leapfrog the arm over the tube, it is necessary to pause the regular measurement and measure 3 more more points in space using the ball probe before and after the leap or move. Then, after the leap, the arm measures the same points in the same order.
In the image on the right, the targets are attached to the base of the tube clamp. This allows the arm to leap the part and continue measuring. Any number leaps can be combined to measure any distance.
The general steps for a leapfrog are shown in the illustration on the right. The exact steps are:

Place at least 3 targets as far from the arm as possible in the direction you want to leap.

Press the LEAP button in the guide window on the left.

Measure the targets with the ball probe. Press the green button to measure each target.

Press the red button to finish the initial measure.

Without moving the targets or the tube, leap the arm over the targets to a new position.

Measure the targets with the ball probe. Press the green button to measure each target.

Press the red button to finish the measure.

The leap is complete. Continue measuring where you left off before.

Target Size

Magnet base diameter	1.50 in (38 mm)
Pillar diameter	1 in (25 mm)
Total Height	1.375 in (35 mm)
Conical hole top diameter	0.365 in (9 mm)
Conical hole depth	0.20 in (5 mm)