Difference between revisions of "Benderlink for SolidWorks"
From ATTWiki
| Line 2: | Line 2: | ||
If a '''measuring center''' arm is setup to sketch a 3D centerline of a measured tube shape, then Benderlink will help you '''reverse-engineer''' tube shapes, and assist in '''correcting''' the bender's data. | If a '''measuring center''' arm is setup to sketch a 3D centerline of a measured tube shape, then Benderlink will help you '''reverse-engineer''' tube shapes, and assist in '''correcting''' the bender's data. | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| Line 27: | Line 13: | ||
<li> - Send new nominal data to benders that support [[SVNET]] protocol.</li> | <li> - Send new nominal data to benders that support [[SVNET]] protocol.</li> | ||
<li> - Make and send correction data to benders that support the [[SVNET]] protocol.</li> | <li> - Make and send correction data to benders that support the [[SVNET]] protocol.</li> | ||
| + | <ol> | ||
| + | <li>Reverse-engineer tube shapes</li> | ||
| + | <li>Correct bender data</li> | ||
</ol> | </ol> | ||
| + | </ol> | ||
| + | |||
| + | |||
| + | |||
| + | http://advancedtubular.com/blink_sw/help_html/clip0003.jpg | ||
| + | |||
| + | |||
The correction feature is peformed by measuring a tube with ROMER / FARO arm, using this data to create a tube centerline in Solid Works, then allow Benderlink to compare this inspected data with the MASTER data. | The correction feature is peformed by measuring a tube with ROMER / FARO arm, using this data to create a tube centerline in Solid Works, then allow Benderlink to compare this inspected data with the MASTER data. | ||
Revision as of 22:27, 28 July 2006
Benderlink for Solid Works software is designed to convert from Solid Works to bender data then to connect Solid Works workstations to SVNET-based benders.
If a measuring center arm is setup to sketch a 3D centerline of a measured tube shape, then Benderlink will help you reverse-engineer tube shapes, and assist in correcting the bender's data.
Features
The main features of this software:
- - Read tube data from Solid Works
- - Convert the tube data to bender data
- - Save / Recall the bender data
- - Send new nominal data to benders that support SVNET protocol.
- - Make and send correction data to benders that support the SVNET protocol.
- Reverse-engineer tube shapes
- Correct bender data
http://advancedtubular.com/blink_sw/help_html/clip0003.jpg
The correction feature is peformed by measuring a tube with ROMER / FARO arm, using this data to create a tube centerline in Solid Works, then allow Benderlink to compare this inspected data with the MASTER data.
[1] Read the online help
--Mcone 13:37, 28 July 2006 (EDT)
