Difference between revisions of "Benderlink Ethernet Module for PINES to Vector"
From ATTWiki
| Line 1: | Line 1: | ||
| − | [[image:Blinklines2vector_pdfimage.jpg| | + | [[image:Blinklines2vector_pdfimage.jpg|200px]] |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
==Description== | ==Description== | ||
Revision as of 13:11, 2 May 2008
Contents |
Description
This is a single port Benderlink Ethernet Module that works with Benderlink for Pines to connect a TS-2000 (Pines) control to an Eaton Leonard Vector 1 measuring center.
Productivity Benefits
100% Eaton Leonard Vector 1 Compatible. Any standard Vector 1 bender port can connect with this module.
Installation Location
It is placed near the Vector 1 Laservision measuring center.
About the Connections
- One RJ-45 port - This connects to the Ethernet.
- One Military Connector - This connector follows the legacy Eaton Leonard style connection. You can connect standard communications cable with circular connectors at either end.
- One Power Port - Any voltage from 90 to 264 VAC accepted.
Inside the Module
This is an image of the inside of the module.
|
|
Example Installation
This is an image of the box installed on a test bench computer running Benderlink for Eaton Leonard, which simulates Vector 1 Laservision communications.
Purchasing
This item can be purchased from our Online Store
Other Pages
- Benderlink Current Loop Module page
- Benderlink page
- Read more about the current loop board here: Communications Board for Eaton Leonard - CB-EL1
