Difference between revisions of "Benderlink Ethernet Module"
(→Setup) |
|||
| Line 68: | Line 68: | ||
*[[Benderlink Module - Laservision to Crown]] | *[[Benderlink Module - Laservision to Crown]] | ||
*[[Benderlink Ethernet Module for PINES to Vector]] | *[[Benderlink Ethernet Module for PINES to Vector]] | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
Revision as of 13:27, 18 February 2009
Contents |
SERIAL Port Benders on a NETWORK
The module connects any bender or measuring center devices through your Ethernet network to a bender that normally connects using only standard RS-232 signals. It gives your bender or measuring center access to a virtual COM port anywhere on the network in your building. Distance limitations are gone with this protocol. We have WiFi (wireless) and WIRED TCP/IP models.
The module can even be equipped with Eaton Leonard current loop boards (our own model) to allow for 100% compatible Eaton Leonard legacy protocol through the network!
Any serial or current-loop bender can benefit from this technology.
Examples:
| Bender | Description | |
|---|---|---|
| PINES TS-2000 | Using Benderlink for Pines - Add a module to a Vector Tube Data Center to enable a network connection through a current-loop module directly into the standard Vector bender port. | |
| BLM VGP | Using Benderlink for BLM - Add a module to Vector Tube Data Center to enable a network connection through a current-loop module directly into the standard Vector bender port. | |
| ROMER to Eaton Leonard | Add a module to any Eaton Leonard bender and make it wireless. | |
| CHIYODA | Add this module to a Chiyoda to allow it to communicate over the network from its RS-232 port. | |
| KEINS | Add this module to a KEINS to allow it to communicate over the network from its RS-232 port. | |
| MiiC | Works with a MiiC to place it on the network | |
PDF DataSheets
|
|
Download a DataSheet for Benderlink Ethernet Module for Eaton Leonard
|
