Difference between revisions of "Bender to XYZ v5.5"
From ATTWiki
| Line 10: | Line 10: | ||
[[image:Bendxyz_calclastlength_from_cutlength.jpg |500px]]<br><br> | [[image:Bendxyz_calclastlength_from_cutlength.jpg |500px]]<br><br> | ||
<br><br> | <br><br> | ||
| + | This command allows for bend charts that do not show the LAST LENGTH value, but assume that it can be calculated from a known cut-length. | ||
== [[image:Check.jpg|25px]] NEW: Automatic Split of 180 Degree Bends == | == [[image:Check.jpg|25px]] NEW: Automatic Split of 180 Degree Bends == | ||
Revision as of 21:36, 18 August 2009
New Features As of August 19, 2009 - v5.5
NEW: CALC LAST LENGTH from CUT LENGTH
A new command was added to calculate a new LAST LENGTH from a CUT LENGTH.
This command allows for bend charts that do not show the LAST LENGTH value, but assume that it can be calculated from a known cut-length.
NEW: Automatic Split of 180 Degree Bends
Large bend angles are now automatically split into two adjacent smaller bends.
Other Pages
- Back to the Bender to XYZ page
- Back to the Conversion page
- Purchase a license in the Online store
