Difference between revisions of "Advanced Tubular Loopback Tester Software"

From ATTWiki
Jump to: navigation, search
Line 43: Line 43:
 
<tr>
 
<tr>
 
<td width=200>This screen shows both the transmit/receive and Request to Send (RTS) and Clear to Send (CTS)pins passing</td>
 
<td width=200>This screen shows both the transmit/receive and Request to Send (RTS) and Clear to Send (CTS)pins passing</td>
<td>[[image:loopback_passfail.jpg]]</td>
+
<td>[[image:loopback_passx3.jpg]]</td>
 
</tr>
 
</tr>
  

Revision as of 18:23, 29 August 2009

The Loopback Tester software is designed to allow you to test RS-232 cables and connectors with only one computer using a loopback connector. A "loopback connector" is a serial connector usually in DB9 form that loops various signals received in the connector back to the signals normally sent out from other computers. This is how the loopback connector is wired:



INCOMING Signals OUTGOING Signals
The RX (Receive pin) is jumped to the TX (Send pin)
The CTS (Clear to Send pin) is jumped to the RTS (Request to Send pin)
In many loopback connectors, the DSR (Data Set Ready) and DCD (Carrier Detect) are jumped to the DTR (Data Terminal Ready)



This forms a complete circuit for testing the original COM port, and all the important connectors and cable in between.

We also use this software to test our Benderlink Ethernet Modules. You can download and use this software for testing the modules also. Here are a few images showing various states of the Loopback Tester software in action.

This screen shows all the controls illuminated at the same time. As the loopback "passes" the test, the Pass bars gets longer and the Failure bars gets shorter. Loopback passfail.jpg
This screen shows both the transmit/receive and Request to Send (RTS) and Clear to Send (CTS)pins passing Loopback passx3.jpg

Loopback passx2.jpg
Loopback failx2.jpg
Loopback passx1.jpg