VTube-LASER v2.9.3
Revision 2.9.3Release Date: January 10, 2017
|
NEW - Support for MicroScribe Arms from Revware
VTube-LASER now supports the MicroScribe arms with the ball probes. These arms measure smaller parts and are therefore less expensive than larger arm solutions. |
NEW - DENGLER Bender Corrections Support
Dengler benders are known for bending long brake and fuel lines. This communications protocol adjusts the DENGLER MES bender files directly that can then ben loaded into the DENGLER controls. |
FIXED and IMPROVED - END TRIM - (Build 108)
A customer discovered a rare end trim condition that we were able to reproduce and fix. The issue occurred when end trim stripes were captured both near the end and near the first or last bend. This confused the end trim logic. The logic has been completely redesigned to not only overcome this issue - but to find the end-trim even faster than before. |
Other
|
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature