VTube-LASER v2.9.2

Revision 2.9.2 Build 104 Release Date: December 1, 2017 Back to VTube-LASER Back to VTube-LASER Updates See also VTube-STEP Updates Download in updates the VTube-LASER Support Page

FIXED and IMPROVED - Split Bend - Finding Surface Edges

As of version 2.9, the Split Bend logic would not find the exact outside of the apex of the surface diameters in 180-degree bends. At best, the split bend centerline would be 0.020" off from the original. In addition to the fix, the logic has been improved to be faster and more reliable than in any previous version.

FIXED and IMPROVED - Bend Profile Calculations

The same issues that affected the Split Bend logic also affected the Bend Profile logic. This has been repaired in this version.

FIXED and IMPROVED - END TRIM

A customer discovered a rare end trim condition that we were able to reproduce and fix. The issue occurred when end trim stripes were captured both near the end and near the first or last bend. This confused the end trim logic. The logic has been completely redesigned to not only overcome this issue - but to find the end-trim even faster than before. Our tests also showed that the end-scan technique is not as important as it was in previous versions. The key is to be sure that the END WALL is the furthest point out in an end scan.

Other

A bug was discovered for saving the Default Project file where some of values recently changed would not be stored in the default setup. This is fixed.

Other Pages

• See VTube-LASER Addata ZModem Communications Protocol for more information.
• Back to VTube-LASER
• Back to VTube Software Updates (for LASER Mode)
• See also VTube-STEP
• See also VTube-STEP Revisions
• See VTube-LASER Customer Support Page to download the latest version.
• See the tutorial on DCF - Dual Cylinder Fit
• See the tutorial on DCP - Diameter Cut Planes
• See VTube-LASER Cut Planes
• See How to Measure Tubes Attached to an Evaporator with the DCP Feature