CNC Bender v15.9.5
From ATTWiki
v15.9.5 - September 14, 2017
|
NEW: Added Jog Motion "End Custom Commands" to Skip Following Custom Commands
When building Custom Commands, it is helpful to be able to indicate when a Custom Command is the last one in order to save time in the run cycle. |
FIXED: Window Border Feature
The Window border feature now correctly maximizes the CNC Bender window when the window border is toggled OFF. |
FIXED: Motion PDA Crash Protection in Manual Absolute
This change is for motion-controlled PDAs. |
FIXED: Galil Communications Reset Issue
CNC Bender can sometimes request a Galil motion controller communications reset on slower computers. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands