VTube-LASER v2.8.1

Revision 2.8.1 Original Release Date: May 8, 2017 Latest Build: 70 - May 6, 2017 Back to VTube-LASER Back to VTube Software Updates (for LASER Mode) Download in updates the VTube-LASER Support Page

BUILD 70 - May 6, 2017

NEW: END OFFSET POINT MODEL

This adds a second end point model of the end point before it is offset. The extra model allows you to visually confirm that the offset point (orange) is based on the correct datum point (yellow) when a Measured offste is used, and/or a ball probe is used on the end. In the top image on the right, the yellow ball represents the middle of the ball probe. The orange ball is the projected end point based on the compensation toward the end. When the two points are within 0.1 mm (0.0039 inches) of within each other, then VTube only draws the final orange ball.

NEW: NOTIFICATION FOR LASER TOGGLE

As of this version if VTube-LASER toggles from LASER to ball probe or ball probe to LASER, it notifies you with a sound and a guide box message.

Other Pages

• Back to VTube-LASER
• Back to VTube Software Updates (for LASER Mode)
• See also VTube-STEP
• See also VTube-STEP Revisions
• See VTube-LASER Customer Support Page to download the latest version.
• See the tutorial on DCF - Dual Cylinder Fit
• See the tutorial on DCP - Diameter Cut Planes
• See VTube-LASER Cut Planes
• See How to Measure Tubes Attached to an Evaporator with the DCP Feature