CNC Bender v14.7

From ATTWiki
Revision as of 22:49, 24 July 2015 by Mcone (Talk | contribs)

Jump to: navigation, search

v14.7 - July 11, 2014

Cncbender v14 logo.png


Check.jpg ENHANCED: Version 14 Is Now Compatible with Legacy I2T Servo Modules

Version 14 introduced compatibility with the new Galil module. This revision allows version 14 to communicate with legacy I2T modules also.

I2T module.png

Galil dmc module.png




Check.jpg NEW: "Custom ALL DIES Open" Option

This new option, when enabled, allows the operator to take over the control of how ALL dies open after each bend using CUSTOM COMMANDS.

Cncbender v14.7 customalldiesopenoption.png





Check.jpg NEW: "Custom ALL DIES Open" Confirmation and Warning Messages

Prebend confirmation messages and warning messages will display when the new Custom ALL DIES Open option is enabled and AUTOBUILD is run.

One of t

The CONFIRMATION message is:

EVERYTHING Looks OK - but this is a check to be sure you intend to ENABLE "Custom ALL DIES Open" after BEND 2.  This means that the dies will NOT AUTOMATICALLY open after this bend unless CUSTOM COMMANDS have been created to handle all dies opening.  If this is what you intend to do, then bring the "Disable AUTO and STEP MODE" to its UP position, which will let you run this program.

The WARNING message is:

WARNING:  There is a BYPASSED COMMAND.  The option "Custom ALL DIES Open" is IGNORED in BEND 2 because the CUSTOM Commands IS NOT ENABLED for this bend. The dies will open using the standard order.  To SOLVE THIS ISSUE, either create and ENABLE CUSTOM Commands for Bend 2, or DISABLE "Custom ALL DIES Open"..


Cncbender v14.7 custom all dies open option messages.png




Other Pages