VTube-STEP v2.1

From ATTWiki
Revision as of 19:58, 24 April 2015 by Mcone (Talk | contribs)

Jump to: navigation, search

Vtube-step logo.jpg

Revision 2.1

Vtube-step-1.87 screenimage.png





Check.jpg ENHANCED: The Path Manager Shows Context

The context of what type of file action is now displayed at the top of the Path Manager to avoid potential confusion.

VTube PathManager ActionContext.png

Check.jpg ENHANCED: CSM and ALPINE File Data Transfer Tested and Improved

  • The CSM and Alpine conversions now correctly invert the rotation value in both M3 and M4 controls - since they move in the opposite direction from VTube rotations.

  • Other adjustments and fixes to the conversion were tested with both styles of bender controls.

  • When VTube sends corrections to the M4 controls, it now changes the adjustment values rather than the nominal values in the YBC page.

Alpinebender.png



Check.jpg Other Changes

  • The VTube configuration file location was changed to the more standard "c:\ProgramData\VTube" location.

  • The installation performs a better job of setting up the configuration file location.

  • The Supravision network engine has been enhanced to handle data files that don't follow the Supravison spec perfectly.

  • We fixed a ball probe measurement issue where VTube would sometimes not always take in single points from the FARO driver. This issue created problems with measuring cut planes too. If you measured cut planes, and still couldn't get the cut plane to work properly, then it was probably due to this issue.


Other