VTube-LASER v1.87
Revision 1.87
|
Contents |
- See VTube-LASER Customer Support Page to download the latest version.
NEW: UniScan
UniScan is a new measurement technique that makes measuring easier, faster, and more precise - all at the same time. |
NEW: Project Open QuickLoad
ENHANCED: Measure Process Menu Reorganized
To help ease the workflow in VTube-LASER, the Measure Tube-Cylinder panel is moved to the top of the Measure Process menu.
|
|
ENHANCED: Straight Count Controls Moved to Setup Menus
ENHANCED: AddisonMckee Mark IV EXTENDED Communications
Some AddisonMckee Mark IV benders require that its custom teach mode data be returned in the communication data during an automated bender correction from VTube. For benders that require this data during corrections from VTube, if this data is not found by the control, then a small message box will appear with a message that the incoming data is not AddisonMckee Mark IV data, and the correction data will be ignored. To solve this problem, VTube-LASER now takes in and stores this data during a RECALL from the bender. When VTube sends corrections back to the bender, it includes this custom data in the transmission. This means that a RECALL is required before corrections are made to this kind of control.
|
NEW: Other Bender Data Setup Menu Changes
|
|
Other Changes
|
Other
- Back to VTube-STEP
- Back to VTube Software Updates (for LASER Mode)
- Back to VTube-LASER
- See VTube Language Editor