CNC Bender v12-20120629
v12-20120629
|
Repair - Processlist Builder Proper Tracking of Option in or out of Toolbox
By default, dynamic options should be OFF or in their DEFAULT state when in a Toolbox.
|
Repair - Robot Clear Bit Can Be High or Low
The Robot Clear bit always assumed that the TRUE signal was bit high. But some machines assume the opposite. This has been fixed.
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands