End-Scan Using the Scissor Motion

How to perform quick scissor motion end-scans. Back to VTube-LASER

Why the End-Scan technique is important

This end-scan method is useful for ease-of-use and quickness. Please keep in mind that our tests show that it is the least precise of the techniques that we recommend. We also recommend the End-Scan Using the End Wall technique and the most precise End-Scan Using End Targets.

Measure Setup

Set System Options, Measure 2 Tab, "Maximum Number of LLP Points in String" to 3 Set Measure Setup - LASER Tab: The LASER defaults to ON for CYLINDERS and END-SCANS. Set Measure Setup - LASER Tab Value: Cylinder stripes = 3 to 5 Set Measure Setup - LASER Tab Value: End-scan stripes = 5 Set Measure Setup - LASER Tab Value: Split bend stripes = 5 Set VTube-LASER so that the Scan Rates are set to TIMER for all scan types. Set VTube-LASER so that the Scan Rates TIMER is set to 0 for all TIMERS.

How To Use This End-Scan Technique

Align the scanner with a slight scissor angle across the end as is shown in the image on the right Press the green button until VTube-LASER is finished scanning all the end stripes.

Other Pages

• See also End-Scan Using the End Wall
• See also End-Scan Using End Targets
• Back to VTube-LASER