CNC Bender v12-20100903
NEW - CYCLE HOLD in Custom Commands and in TEACH Mode
Now CYCLE HOLD anywhere inside a CUSTOM COMMAND either manually entered or taught during TEACH MODE. |
|
ENHANCED - ENABLE Button for STEP and AUTO Modes
The "REQUIRE ENABLE BUTTON" feature, when active, now also monitors for a switch to AUTO or STEP modes from MANUAL mode |
|
ENHANCED - Vertical Head Shift Tolerance Added
The vertical head shift tolerance allows us to skip motion when an axis is close enough to the final position. |
|
ENHANCED - Added CNC Processor Automatic High Pressure Handling
CNC Processor now uses the CIO Name Cross Reference in the Low Level menu to automatically set the high pressure under these two special circumstances:
|
|
NEW - Added Speed Ramp-Down for Direct Axis Jogging
This new feature allows any axis to be direct-axis jogged using a joystick, pendant, or screen buttons with the assurance that the jogging motion will not exceed the soft EOT (End of Travel) limits feature added in the prevision revision. |
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands