Revision: Benderlink for BLM 4

From ATTWiki
Revision as of 08:18, 17 April 2009 by Mcone (Talk | contribs)

Jump to: navigation, search

Benderlink blm logo.jpg

Blm e-bend76.jpg


Check.jpg NEW - Completely Redesigned Interface

The interface has been updated and reorganized for easier reading with many new features for ease-of-use.


Blinkblm v4.jpg

  • New - Quick Load and Merge BLM Buttons
  • New - Large LED numbers that indicate, in real-time, the byte count coming or going.
  • New - Large Monitor speed button for switching between MONITOR ON/OFF for waiting on measuring center commands.
  • New - Four new Date/Time labels show when data was last transmitted in any direction
  • New - Attention Grabber Logs that flash when the operator should know that something important just happened in the logs




Check.jpg ENHANCED - Updated Eaton Leonard Protocol Handling

This Benderlink now communicates with Eaton Leonard measuring centers using our new current-loop technology that is compatible with the Eaton Leonard legacy protocol. The new engine for communication handling is much improved over older versions.


Vector tube data center.jpg

Check.jpg NEW - New Help and Manual

The manual and help system are completely rewritten with new information that includes...

  • how to install Benderlink
  • how to install the Benderlink Ethernet Module
  • how to use the software - in much more depth

Blinkblm help.jpg




Blinkblm online help.jpg




Check.jpg NEW - Edit the BLM YBC Data Before Sending the Corrected Data to the Bender

This new capability allows the user to fine-tune the corrections before they are sent to the BLM. For example, a 270 degree rotation can be switched to a -90 degree rotation with the press of an inversion button.
Blinkblm editdata.jpg

Blinkblm editdata2.jpg

Check.jpg New - Check for Matching Part Number - Either ON or OFF

This new feature allows you indicate whether you want the part number to match between the BLM and measuringc enter:

  • UNCHECK: to setup new parts and ignore the part number during transmission.
  • CHECK: To prevent accidental mixing of two parts by making the two systems pay attention to the part name.

Blinkblm checkformatching part number.jpg



Check.jpg New - Confirmation PING for the Benderlink Module

This allows Benderlink to check for a PING response from a Benderlink Ethernet Module. If the Benderlink Ethernet Module responds to a PING, then it is ready for communication with Benderlink. This test makes testing networks much easier.

Blinkblm confirmationping.jpgBlink ethernet module vector benderside 600.jpg



Check.jpg New - Setup and Diagnostic Utilities for the Benderlink Ethernet Module

The Benderlink Ethernet Module support software is included in the interface of Benderlink for easy access.

Blinkblm newsetupmenu.jpg



Check.jpg New - Date and Time in Status Bar

The current date and time are now always displayed in the status bar

Blinkblm datetime status.jpg

Other Pages